Lure for needle jig V4

cults3d

here is a lure for needle jig, version 4: Accessory in 4 pieces to change a 15cm needle jig into a "non weighted" jig. It is a full-fledged model that would differ a little from a possible "v4 jig" (another of my models) just enlarged to 124 percent. Among other things, the shape that accommodates the shaft is optimized. -tinted in the mass; no too fast fading as on some models with coatings. -combinations of colors -the "basket" part of the needle jig being already done, this model is easier to finalize than a model where you have to prepare a shaft yourself. For an assembly with a wire underneath which supports a pear lead (drop shot style), or on line body. this time, this version uses preferably a translucent material bottom part, and the phosphorescent inserts are inside this translucent part. So you can see them through, and the phosphorescence gives an interesting more diffuse look. (see photo of the similar effect) The "neutral" "colorless" or "crystal" or "transparent" PLA or transparent PET , or other translucent filament, are strongly recommended for the bottom part you also need "phosphorescent" or "glow in the dark" for the interior inserts as the inserts are inside, it is advisable to use a small uv lamp to illuminate them more effectively through the translucent bottom at night during your fishing session. and finally two other colors; one for the back and one for the side stripes -You need metal "needle" jigs of about 15cm (normally intended for fishing with fresh bait) -soft pearls of about 5mm