Lunging Elephant

thingiverse

I remixed a single model to fit my preferred pose, flipping it 180 degrees to minimize filament waste. The model has a slight imbalance towards the head but I've made some minor adjustments by sanding down the front left side. The problem is now resolved. This 3D print was produced on a Wanhao clone, specifically the Monoprice Maker Select Plus. Here are the settings used for the ColorFab Bronzefill print: * Print speed: 50 mm/s * Extruder temperature: 205°C * Bed temperature: 0°C with green painter's tape * A brim and supports were also added to ensure stability. * The flow rate was set at 104%. Please note that the picture is unedited and not touched up in any way.