Lundia 30cm deep shelf ladder filler

thingiverse

This shelf filler fits inside a 30cm deep Lundia ladder shelf, filling the hole and bringing it up to level with the ladders themselves, allowing storage of literature and graphic novels in an orderly straight line. The filler is designed to be used in ladders without official Lundia panels. To use this filler, lock it in place with four wedges. Insert two wedges into ladder grooves with narrow ends pointing upwards, resting on top of the shelf support. Then, insert the filler into the groove, pushing down between the two wedges. Finally, slip two wedges into ladder grooves behind upper corners of the filler. Enjoy storing your books without them falling out through the ladder. Official Lundia fillers require you to disassemble the shelf and start assembly by inserting the fillers. These functional and simple fillers improve on this design aspect. Printing one filler with a 0.2mm layer height and 10% infill takes approximately 19 hours using a CR-10 printer. You'll need two fillers for each shelf, giving you plenty of time to visit the Lundia factory by boat - in theory, since in practice you'll be busy looking after your printer. You could also get these cut out of plywood at a local shop for a fraction of the cost, supporting your local economy. However, printing these designs gives you that nice feeling of accomplishment and may impress your relatives as groundbreaking research. Store your books with ease. To print this item, use 120g of filament with 10% infill, four top and bottom layers, three perimeters, and a 0.4mm nozzle. For best results, print the largest face down.