Lulzbot Taz Workhorse PanelDue LCD mount

thingiverse

I swapped out the original LCD screen on my Taz Workhorse for a PanelDue display, and I must say it was a game-changer. The cutout dimensions are 80.65mm x 53.15mm, which should fit any other Lulzbot printer just fine. The PanelDue case from LumberjackEngineering is a great addition to my setup, and the design allows for plenty of room to route cables to the display. I used a pivot mount that screws into the snap-in mount, securing it with 4 M3 screws, nuts, and washers - at least 10mm in length. The snap-in mechanism is surprisingly snug, but it gets the job done. However, keep in mind that this design may not leave enough space for an enclosure if you plan on using one. I apologize for any inconvenience this might cause, and I'll definitely rework the design if I decide to go back to using my enclosure. The PanelDue 5I looks great installed on my Taz Workhorse, and it's a relatively straightforward process to get everything set up. I should have taken a picture before assembling it, but I'm sure you can figure it out from here.