Lulzbot Taz 6 Printed Solid Top Plexiglass Retainer Clips

thingiverse

I have the Acrylic (Plexiglass) Enclosure from Printed Solid for my Taz 6. With that enclosure, a piece sits on top where filament is fed through, but it tends to slip off and interfere with prints occasionally. These clips are designed to prevent this issue. To install them: Remove the two inner-side M5 screws securing the Z-Upper top plate into the T-nuts from both left and right sides. Install the plexiglass top piece from Printed Solid. Install the clips over-top of the holes revealed in Step 1. Re-install the two M5-screws (now using M5x12mm; set aside the M5x10mm for now), slipping them through the retainer clips and back through into the T-Nuts. Tighten firmly. That's it! Note: You'll need to switch the pre-installed M5x10 screws with M5x12mm BHCS black oxide screws. Use these clips at your own risk, as they may void your warranty with Lulzbot.