Lulzbot Taz 6 filament sensor + guide

thingiverse

I installed all my printer sensors with the latest Lerdge v2, micro-switch filament sensor and it has been working fantastically. This incorporates the sensor directly into the filament line utilizing a tube spinner designed by Lulzbot. The STL also includes a filament tube guide designed by mantisrobot (https://www.thingiverse.com/thing:2568172) Lerdge v2 sensor can be found at https://www.aliexpress.com/item/32819132939.html?spm=a2g0s.9042311.0.0.5b8c4c4d8iJmgY To use: Print the part, insert the sensor, and wire it up to an octoprint-enabled raspberry pi (RED power->pin 02, BLACK ground -> pin 06, WHITE signal -> pin 07) Install the Filament reloaded plugin for octoprint: https://plugins.octoprint.org/plugins/filament_sensor_reloaded/ Plugin settings: insert into GCODE box in settings: M300 ; beep sound M600 X220 Y17 Z20 ; move Z up +20, move bed to rear for easy access nozzle Check the Send GCODE once box Uncheck the pause Print box Print until filament runs out, Taz will run a filament change routine, insert more filament, hit resume on LCD, and then un-pause print in octoprint. That's it.