lulzbot retract settings & marlin fw

thingiverse

I was struggling to get my retract settings just right on my 3D printer, so I decided to do some research online for configuration files. That's when I stumbled upon Lulzbot, which offers Cura settings for almost every commercially available filament out there. I had also recently updated my firmware to the one used by Lulzbot printers with a slight modification. If you're interested in using my firmware, be aware that you'll need to modify it to fit your specific setup. My current settings are set up for dual extruders, temp sensor 11 on both hotends, auto-leveling enabled and MK8 direct drive gear. The cube is there just because I had to include a picture with this post. Custom Section: Retract Settings: Using 1.75mm filament as default: Travel speed = 175 for all Cool min layer time = 15 for all ABS: Retraction speed = 10 Retraction amount = 1 Retraction dual amount = 16.5 Retraction min travel = 1.5 Retraction combining = All Retraction minimal extrusion = 0.005 Retraction hop = 0.1 HIPS: Retraction speed = 10 Retraction amount = 1 Retraction dual amount = 16.5 Retraction min travel = 1.5 Retraction combining = All Retraction minimal extrusion = 0.005 Retraction hop = 0.1 PLA: Retraction speed = 25, previously set to 10, default speed works well with geared extruder "tested" Retraction amount = 2.7, was previously set at 1.7 Retraction dual amount = 16.5 Retraction min travel = 1.5 Retraction combining = All Retraction minimal extrusion = 0.005 Retraction hop = 0.1 Nylon: Retraction speed = 10 Retraction amount = 2.5 Retraction dual amount = 25 Retraction min travel = 1.5 Retraction combining = All Retraction minimal extrusion = 0.02 Retraction hop = 0