Lulzbot Mini UDOO Mounting Bracket

thingiverse

Mount a small UDOO Quad next to the Lulzbot Mini. To run OctoPrint using my UDOO, I have the following needs: Nylon M3x9 screws - 5 8 Nylon M3 nuts M3 Tapping tool Here's how to mount it: First, tap all four holes, except for the center one. It doesn't require tapping. Next, screw the bracket on with a single M3 nylon screw to an existing M3 hole found on the side of the Lulzbot Mini. Check if there is already a screw in place holding down the power supply unit (PSU); mine was missing, and it isn't clear what the correct setup should be, but just remove the screw if necessary - its sole purpose is to hold the PSU. Then, align four M3 nylon screws on the UDOO and securely attach two nuts each. Don't over tighten the nuts so that the screw can still turn easily (they serve as spacers). Lastly, securely attach all 4 of those previously attached M3 nylon screws onto the mounted bracket and make sure the PSU Connector is facing the back of the Lulzbot Mini.