Lulzbot Mini 2 DropCam Low Camera Mount

thingiverse

This design was originally created by Raffen for his Lulzbot Camera, and the original mount worked flawlessly, but since it was designed with an older model in mind, adjustments were necessary to accommodate the newer model's build plate. To make the DropCam mount assembly process smoother, printable screws and nuts were added to the design. The center peg is the only component that requires supports, and for optimal results, I recommend printing all bolts and nuts at 100% infill with a layer height of .18mm. On my printer, the side bolt tends to print slightly smaller than expected, so I suggest increasing its infill to 95% to ensure a snug fit. To achieve a smooth finish, light sanding is recommended, and in some cases, drilling out a notch may be necessary if a screw prevents the entire rig from sliding into place due to interference.