Lucy With LED

thingiverse

A little nightlight crafted from Mere's Lucy the Cat figure. I carved out a cavity in the bottom to accommodate the electronics of a tealight. An RGB tealight was used, which glows very nicely. The tealight center portion must be removed from its outer shell. This was done so that most of the cat's body would light up and maintain a lower overall profile. A small hole marks the center of the cavity in the bottom. This has to be drilled or punched out to make room for the LED. The cavity is 38mm in diameter, which is sufficient for most tealights' internals. Parts: 1. LED tealight Hot glue or other adhesive Printing: 2-3 layers, NO INFILL, support touching build plate A layer height of .12 was used