Luces led en Kossel linear plus

thingiverse

I needed to see the bed of my printer, and I decided to put some LED lights on the head of the printer. I've seen several ways to do it, but this one stands out because you don't need to disassemble anything from your printer to put in and take out the circle of LED lights. This opens up the circle, and in the photos I've left, it's clear as day. So you can stick it between the heater cables and the sensor, plug it into the cable that goes to the switch, and you're done. I put the button on the power supply because there's a lot of space, and the supports I printed with transparent PLA after making a small rebate with a "toro" so they sit better on the LED strip. The LEDs were bought from eBay: https://www.ebay.com/itm/2x-70mm-COB-LED-Angel-Eyes-Halo-Ring-Light-Car-Headlight-DRL-Lamp-White/192541849063?ssPageName=STRK%3AMEBIDX%3AIT&_trksid=p2060353.m2749.l2649