LTT screwdriver case w bit storage

thingiverse

I designed this case because I didn't find any great options to store my screwdriver including all 60 extra bits. The bits are held in by small magnets (5x2mm). The big magnets for closing the box are 8x8mm which gives a nice "snap" when you close the box (I used 2 sets of [Trendform Bolt](https://trendform.com/inten/trendform-items/magnets/superstrong-magnets/5325/magnets-bolt-set-of-6-silver), although cheaper/weaker magnets may be used depending on your preference). I glued those magnets in using instant glue. For the smaller magnets underneath the bits I used some no-name cheap magnets. [These](https://www.amazon.com/FINDMAG-Refrigerator-Magnets-Premium-Whiteboard/dp/B08M3GHMWN) should do just fine (although I chose an even cheaper alternative which was available locally). I stuck the magnets down using double-sided (carpet) tape (instant glue should work as well). For the logo I used matte lacquer NCS S 0585-Y70R, which was the closest I could find to LTT orange/red. > NOTE!!!: Only the LTT-shorty bits will fit in this case!