LTT Screwdriver Bit Holder "60" with Magnets

thingiverse

This is a Remixed Design of "handsomeharold's" LTT Screwdriver "shortie" 60/48/36 Bit Holder V6.2. I will leave the Links down bellow to the magnets I purchased for this project. I liked the bit holders themselves but I wanted a better way to keep them in place and to close the box. I took the original design and added extra depth to the holes for the bits to fit some round magnets the keep the bitts held in place. I designed it so the magnets are press fit into the holes created so no glue is necessary to hold the magnets in place. depending on the tolerances' of your printer you may need to increase or decrease the overall size of the print, so I have included a quick test print that should allow you to test that tolerance The test print is is the exact size of the holes used in the full model it is to test how well the magnets fit into the print. The fit should be pretty tight but it should fit easily enough. The test print is rather small so I would suggest that you **Print The Test with a Brim**. The magnets for the lid should also be a tight fit on mine however the fit on some of the latches was not good enough so you might need a little glue for those pieces. I have tested this with my own printer as well as the LTT bits and it fits and functions well. Let me know if you print this and how it turns out. **Round Magnets for the Bits** https://www.amazon.com/dp/B09QHT4W1W?psc=1&ref=ppx_yo2ov_dt_b_product_details **Rectangle Magnets for the lid and bottom** https://www.amazon.com/dp/B09HBSYXR8?psc=1&ref=ppx_yo2ov_dt_b_product_details