LTT+iFixit Mod-Case - Now with Gridfinity support

thingiverse

*****UPDATE 2***** Thanks to @modernespiel for Making a split version of the bottom case that has Gridfinity support. It also has spots for recessed 3x3mm Neodymium magnet in the four corners. Expect my next update to add the magnet holes to the other models and hopefully make a lid that goes with them. You can see @modernespiel's design here: https://www.thingiverse.com/thing:5792535 -------------------------------------------------------------------------------- *****UPDATE 1***** Added a split version of the bottom case. I have not done a split for the top yet as I still have no Idea how I'm going to attach it to the bottom. -------------------------------------------------------------------------------- I've been working on this for a while and it is very not done BUT it's close enough that I think It's time for some help from the community! This was designed so it will Technically fit in the iFixit Pro Tech Tool kit v1 case. It is however longer and taller than the original driver case but the elastic stretches enough to hold it. The Hex bits on the right side are made for the "shorty" bits of the LTT Screwdriver. The ones on the left are for the more standard 25mm bits and is a great place to put the adapter for the iFixit bits. This thing barely Fits on my Ender 3 Pro so printing it has been a challenge and the only Good print started to Curl but almost everything was perfect otherwise so I'm using it as is for now! I have not printed the lid for 2 reasons. 1. I'm trying to get my bed adhesion right so it doesn't curl 2. I still have no Idea how I should attach it so the bits don't fall out Any help with a good way to attach the lid and keep the Hex bits in place would be greatly appreciated!!! also if you make a Tray for it I can add it here or link to it for you. I have also made this compatible with Zack's Gridfinity system It fits in a 5x2 grid it is however centred so if your grid is taller than 5 then it will block spots on the top and bottom. Let's answer some Questions: Q. Why is there a separate tray for the screwdriver handle? A.Designing the holder took FOREVER and I had to print it every time I made a change, so i trimmed it down to just that tray so i could save on print time and make tiny changes. Then i realized if i just made it so this could just slot into the case then others could just make their own tray for other screw drivers so i left it that way. ASK More Questions and I'll answer them here!