LS1 LS2 LS3 LS6 LS7 lifter & pushrod holder

thingiverse

This should work for all standard LS engines, the pushrod diameter is 5/16" with standard lifter diameters. I rounded upwards so there will be a little lose fitting, pushrods come out at 7,9375mm and I made these holes 8mm and the lifters are at 21,3868mm and I made these to 22mm (might have been a little too lose on the lifters but I think they will work fine). The entire board is 200 x 200 or 7,87" x 7,87" NOTE: the V2 version has it's pushrod holes enlarged to 8.5mm instead of the 8mm, this was due to my printer not really making 8mm holes instead it made 7.8 mm holes. This can be fixed if you fine tune your printer but in case you are like me and haven't gotten there yet the V2 should work like a charm. Printing: I printed this with 20% infill which I think is fine. Material used is PLA, but use whatever you feel works for you. Print speed 50mm/s on infill and 25mm/s on the rest which was a huge mistake, use around 50mm/s on everything I'd say or as fast as you feel comfortable with both in regards of your printer and filament used.