LowRider V2 - DW611 Pen Holder

thingiverse

This is a versatile pen holder that easily snaps into the DeWalt router plate, standard on the Low Rider V2. Simply pull out the router or retract it if you're using a short pen and then snap in the disc from underneath. Compatible with my Z-Probe, so it will automatically detect the pen height. I strongly recommend printing this design with PETG or Armadillo/Nylon for the best results. I appreciate this design because the pen is positioned where the cutting bit normally resides, allowing you to preview where cuts will be made and also use it to draw a positioning grid on your table within the cutting extent of your setup. This innovative pen holder was inspired by Alted's design and those small plastic discs found inside 45 records - just ask your parents about them!