Lower chassis brace 4 Maker Select V2 & Wanhao Duplicator 3

cults3d

The lower chassis is made of 1.5mm thick bent aluminum and is quite flimsy. Everyone adds the Z brace and it greatly helps but no one noticed that the base can easily be bent or miss-aligned . These little braces will allow a much better hold on the "Squareness" of the base. there are a few holes where you can install some M3 screws and nuts but you will have to drill them out with a 3mm drill bit once the braces are inserted onto the base. They fit fairly snug so you can probably even just pop them on and they should hold. If not, drill out the holes and insert some screws.