Low profile USB and Micro SD holder for Ender 3

thingiverse

A low profile USB and Micro SD card holder for the Ender 3 and printers with 40x40mm aluminum extrusions. It should be a tight fit to replace the front end cap. Prints only with 45 degree overhangs (no supports necessary). Print with the large 45 degree chamfer on the bed so whole model is printed at an angle. Not sure why I included 2 micro SD card holders, but I did it anyway since there was enough room. Send me a message if the tolerances need adjustment! Note: Model is meant to be printed at a 45 degree angle for a few reasons: - The studs are a little bit stronger so they don't snap off as easily - No need for bridges or supports. - Front face surface quality is better (mostly just for people like me who don't like the texture of their bed; mine is masking tape)