Low Profile Filament Holder

prusaprinters

This is a low profile Filament Holder, what makes it low profile is that the spool sits about 2mm of the surface the holder is on. Here is the story:I was at a store and seen a container that was airtight and looked like it would fit 2 spools of filament. So next weekend I went back with 2 spools and checked and sure enough 2 spools fit. When I got home I did not notice something about the lid in the store, it sits lower then the top of the box to make the handle flush with the top of the box. I searched and search and could not find a filament holder that would make the spool low enough for the lid to close. So I learned Fusion 360 and made this low profile holder. You can also join holders with the screw/bolt hole that is located in the middle of each side.You will need:4 of 608zz ball bearings10 of M2.5 x 20mm screws (14-20mm screws will work)1 of M2.5 x 6mm screw and M2.5 Nut (if you want to join 2 holders together)4 Clear Bumpers 1/2 inch (Everbilt SKU#158724 at Home Depot)