Low Polygon Mask with breathing holes

pinshape

I remixed the thin version of the Low Polygon Mask, completely rebuilding it from scratch using the original as a template. This new model is wider on the jaw and cheeks, with a thickness of 2mm throughout. I increased the thickness to save filament in areas where it was previously thin. The eyes are no longer squinting, which improves visibility, and the eyelashes now sweep across the edges. The mouth is now open with a slight grin, allowing for easy breathing or sticking out your tongue. I added a buckle to the head strap, which should be approximately 1/2 inch in width. This model fits comfortably on a 6" x 6" bed. Print Settings: * Rafts: None * Supports: None * Resolution: 0.2mm * Infill: 15% Notes: I recommend printing the mask with PLA for a better fit, as it can be heat molded to conform to your face. You won't need supports, but I used honeycomb infill in natural PETG and printed my mask in about 7.5 hours.