Low poly wine glass

thingiverse

Low poly wine glass of 200ml capacity. I used colorless filament, 2 walls and 7% gyroid infill pattern so it would nicely standout through walls. In one model under foot there is screw for M10 nut, to weight model down, so it wont flip too easily. Support is only required for foot, all other angles are handled below 60 degree, so with 0.2 resolution, overhangs shouldn't be an issue. Since whole vessel is supported on its neck, during printing upper half, slow down, as excessive speed will cause model to vibrate too much. Linear advance is helpful, but optional. Took me aprox. 9hrs to print. Finished print seal with non toxic, alcohol resistant coating, to prevent sapping fluids into model.