Low Poly IEM Earphone Stand

prusaprinters

A simple stand for your IEMs, earphones or earbuds.The stand consists of three parts. The base, the arm and the cable spool, each part comes in different variants.Base: There is a slim and a wide version of the base and both versions are available as “basic” with no headphone jack hole or with either a hole that fits 3.5mm or 4.4mm jacks.In addition there is also an even wider version with a cutout if you simply want to place your cable into the base. This one also comes as “basic” or with a hole that will work with 3.5mm and 4.4mm jacks.Arm: There is a short and a longer version of each arm and three different variants. “Hook” works well for typical behind the ear cable IEM, “cutout” works well with any kind of earphone and “showerhead” will work well with the so called showerhead or earbud form factor. Spool: The spool simply comes in 3 different variants. “Basic” with no headphone jack hole and two versions with either a 3.5mm or 4.4mm jack hole.No supports needed except for the “hook” arm, which will require tree support touching baseplate.The model work great ta 10-20% infill, but for the slim base i recommend 40%+ infill to increase stability and weight.!!NOTE!!: The fit on this model is very tight. It will work with 0.2 and 0.4mm nozzles at normal speed, but if you print with a bigger nozzle and higher speed i recommend sclaing either the base to  100.5 or 101% or the arm and spool to 99 or 99.5% for better clearance/easier assembly.