Low Poly Chicken

thingiverse

It's a low poly chicken, what more could you ask for? Thanks to dejavuus for the original. This chicken balances remarkably well on its own, but the legs are surprisingly fragile and may need additional support to stand firm. To address this issue, consider adding a small disk beneath it to enhance stability. I experimented with 4 perimeters and 80% fill, but even then, one leg snapped off after dropping it from about 500mm. Fortunately, gluing it back on restored its original appearance. The main body printed successfully with 0% infill, but if you're unfamiliar with printing overhangs, you may want to opt for a 10% fill to ensure the back's flat areas remain sturdy. My print exhibited a noticeable thinness in some regions, likely due to an overheated print temperature that compromised the infill. To mitigate potential problems, I employed supports strategically in areas like between the legs, under the tail, and chin. However, if you're more experienced with printing, you might be able to forgo them altogether. As a novice myself, I'm still learning the ropes. Keep in mind that this design can benefit from scaling up – mine turned out quite small. Unfortunately, I no longer have access to a photo without supports, as I've already gifted it away.