Low-Poly Baby Yoda book stand / book end

prusaprinters

This is a book stand for your library that makes it look like Yoda is holding your books using the Force.Since the models are separate and the pin holding the character in place is on the book stand part, you can also just print the Yoda as a figurine.Check out my Darth Vader model, compatible with the same book stand, if you are on the dark side of the Force: https://www.printables.com/model/432680-low-poly-darth-vader-book-stand-book-endPrinting settingsFor the Baby Yoda:Print it standing,Supports enabled (you can use support blockers for a lot of parts, they are mostly needed for the hands and one of the ears),Layer height: 0.15mmInfill: 20% cubic subdivision, but lower would probably also workPrint time: Around 5 hoursFor the stand:Print it on the side, this will make it stronger when it comes to holding the books,Supports enabled (only needed for the pin, it almost doesn't add any time / material),Bed adhesion: A brim may be needed, depending on your printer / filament,Layer height: 0.2mm (you can probably go higher)Infill: 100%, it needs to be strong to hold the booksPrint time: Around 10 hoursExtra notesThe pin and the hole are a very tight fit, you will probably have to sand the pin a bit, but it's easy to do.If the book stand slides due to the weight of the books, use some adhesive putty like Blu Tack.