Louis Tomlinson Walls Spinning Dartboard

thingiverse

This was obviously inspired by the Walls video clip from Louis Tomlinson. It's the design of a dartboard that spins and always (or that's the idea) stops with the silhouette of our protagonist in the correct vertical position. I have printed all the files face down on a glass bed, this way it has a glossy finish. See more: https://www.instagram.com/p/CNK1Re9FfQM/ https://www.instagram.com/p/CNdG5hwre7z/ **For printing the dartboard there are 3 options:** 1. Print Black, White, Red, BackBolt separately and glue everything. 2. Print Black, White and Red like in the video (linked below this) and then separately print BackBolt and glue these two prints. Use z-hop 0.7mm (Black, White and Red height are 0.6 mm) to make sure that the extruder doesn't bump on any previous print and also enable z-hop when retraction. 3. Print White, Red and BlackBackBolt like in the video with 0.7 mm z-hop and enabled z-hop when retraction also. **Colorful 3D Prints on a Single Extruder Printer // Artistic Phone Cases by Make Anything:** https://youtu.be/KV2AjyowXX4 **Nut fitting problems:** if you have any problems try to scale down or up the model a little to try to make the best fit with the calibration and resolution of your 3D printer. *Print settings for each piece below.*