Losi Junior 2 chassis sized for Mini Jrx2 WIP

cults3d

Update: Added a reinforced chassis brace because it was a bit thin over the servo horn cutout, this is a deviation from original but should not cause any issues. A living project tends to get updates, As I gained parts for my junior project I found a minor issue that needed rectification. The larger relative size of the ball joints on the mini scale chassis caused interference in the suspension and steering rod ends so I had to move the bellcranks back by 2mm, in this update I also enlarged the holes that screw into the rear bulkhead tie rod holes as I found the bulkhead holes to be for 2.5mm screws instead of 2mm as well as labeled the chassis under the bulkhead so it has the version number on it. I also continued the chassis brace holes through to the bottom as per the full size chassis. If you have already printed the v1.1 chassis I have also included short bellcranks that will allow those chassis to work just fine. There is servo saver and rigid arms available. As for now, the chassis should be fit for use. I designed this to fit with the new Mini Jrx2 parts so some details are slightly different from the original chassis. I have not yet printed this final version but it looks like it will be a bit tricky to print. I have not yet modeled the chassis brace that will probably be next.