Lorei spool holder

thingiverse

Spool holder for XMachines Lorei printer. Attach it to the back using two cover plate screws. Insert a piece of 1/2" PVC tubing, cut to your desired length. I created a taller version for larger spools that is also flush with the edge of the printer. An end cap keeps the spools from sliding off the end of the PVC. The taller version was too flimsy for large spools. I made rev 6, designed for use with some 1/2" PVC, nice and sturdy, holding two large spools without issue. I added a hole in the front for a screw to hold the PVC in place but it fit so tightly that a screw wasn't needed. Parts needed for rev 6: 1. 5" x 1/2" PVC (cut one end at about a 30 degree angle to fit to the bottom of the base) 2. 4" x 1/2" PVC 3. 1/2" TEE PVC 4. Printed rev 6 base 5. Two printed end caps