Longboard Skateboard Hanger #SKATEFORCE

thingiverse

My entry into the PRESS RESET longboard challenge is finally here! Check it out on YouTube: https://www.youtube.com/watch?v=pVH-GfD4Sfo You can print the V8.STL file as-is, no need to rotate it. Although it does require two hangers, one for each front wheel, don't worry about left or right sides - just flip it around and hang it on the wall in a different direction using the other holes. This design is perfectly mirrored on both sides. I made sure to create it specifically for #10 screws. Additionally, you can use washers or fender washers for extra strength, but they're not necessary. The hanger should be able to handle 90mm or smaller wheels without any issues. Take a look at the pictures and you'll see my test rig and the hanger right after I removed it from the printer. One test shows a fender washer in place, while the other is just a screw with no washers. The hanger held an impressive 5 gallons of water plus extra weight from the bucket (1 pound 9 oz) and the clamp (1 pound 6oz) during both tests - it didn't break or separate! However, when exposed to the California sun with the added weight, the hanger did deform slightly. But don't worry, the 5-gallon bucket remained firmly suspended in the air, never touching the ground. #SKATEFORCE