Logitech Wingman Dust Gasket

thingiverse

I had a Logitech Wingman Force for ages.Was a great joystick and used for such a long time, but the silicone dust & centering gasket finally disintegrated.For those who may still use this controller, this part will give it a bit of new life.Note:Must print with flexible filament (TPU - 95A,80A,60A)This dust cover might work for a Logitech Extreme 3D joystick.I cannot advise if this part will fit on any other Logitech joystick, as I do not own/have others to compare or test.Recommended model is "Short-15mm" if using firmer TPU 95A filament.Printing the full size gasket with 95A will cause too much movement resistance.DustCover_FlatTaper-Short-15mm - TPU ~95A will work fineDustCover_FlatTaper - Only Print this one with really soft/flexible TPU (60A,70A, maybe 80A)DustCover_Spacer_Ring-Tapered - Use this to close off the center-hole gapGeneral Disclaimer:By making/using this part, you take full responsibility for the handling and application of your device/property.We cannot be held liable for any damages or loss.