Logitech StreamCam Snap-on Cover

prusaprinters

<p>I was looking for a protection cover that is suited for transporting the Logitech StreamCam. The covers I found were a bit loose and wouldn't stay on the webcam so i designed one with a snug fit and two hooks to prevent it from slipping off during transport.</p><p>It is designed with tight tolerances to ensure a good fit and a close sealing on the open edge.</p><p>Please note the <strong>post-processing notes</strong>.</p><p>Printed in 0.2mm Quality setting and Fillamentum PLA Extrafill Mint.</p><h4>Post-processing</h4><p>The two snapping hooks need to be cut at an angle (roughly 45°) by hand to create a smooth plane*. You need to use a sharp knife so <strong>please be careful</strong>. I posted a picture showing the spot you need to cut.</p><p>*This is necessary due to the layering that occurs with FDM-printing: the angle I originally designed created steps that prevented the hooks from sliding smoothly over the webcams edge.</p>