Logitech G29 Quick release system v2.2 for Aftermarket Steering Wheels!

prusaprinters

Logitech G29 Quick release system v2.1 for aftermarket Steering Wheels! Description: Like said in the title this is a quick release System for the Logitech G29. With this system you can attach aftermarket rims with no problem. There are two sizes(outer and inner holes) Size 1: Logitech screw holes (inner holes) Size 2 :Aftermarket Steering wheel screw holes (outer holes) Parts needed: Bycicle Seat Post clamp with the diameter of 34.9mm Screws for Wheelbase and Aftermarket Wheel Installation: (You might need to sand down some of the parts depending on the print quality) Part 1: Part where the clamp gets attached(picture number one) Part 2: Part that goes onto the wheel (Picture two) Part 3: The Small part in picture three 1.) Put part 3 into part 2. 2.) Screw Part one onto the Wheelbase 3.) Screw Part 2+3 onto the Wheel 4.) Attach the bike clamp to Part 1 5.) Put Part 2+3 into Part 1 6.) Tighten the clamp 7.) Enjoy! Keep in mind that this is not fully released yet! If you enjoy my work show it by commenting and sharing this Thing. If you reupload this Thing anywhere, link this Thing to it! Category: DIY