Logitech Camera mount for Monoprice Maker Ultimate/ Wanhao Duplicator 6. C270/C310 camera.

thingiverse

I wanted a camera mount that more closely follows what the print head is doing, not disappearing down on tall prints. I also wanted to use a $10 C310 camera I picked up from eBay. I remixed a few designs I found to make this fit. The wires tuck clean and I snaked the USB through the base. The camera was also pushed slightly forward to clear the chassis/doors and fit comfortably inside. I also made the bracket 1mm thicker as it was a bit fragile to print before. Plenty of clearance from the print head and cooling duct. It has reasonable coverage, but, will likely do better with a wide angle lense retrofit. You might need to foil wrap the wiring to prevent signal interference from the LED light if you follow the gromet wiring.