Logitech c160 to GoPro mount adapter

cults3d

I took the screw out of the side of my webcam and then took off the faceplate. Then the housing was able to be pulled apart and that released the mounting point at the bottom. Then I took measurements of the complex geometry and remade it in TinkerCAD. Then I cut the mount point off the dual GoPro adapter and stuck it on. After that I realized that with the geometry that's there, there wasn't a good way to print it, so I cut it in half and put a hole in each half as well as a small rectangular piece to fit into the holes to fit it together. I then reassembled the camera with the new piece installed (after gluing it back together of course). I'll be using this with the Ender 3 handle with the GoPro mount. Also uploaded a picture of it installed on my camera. Not sure why Thingiverse turned it and squished it, but you get the idea.