Logitech c160 to GoPro mount adapter

thingiverse

I removed the screw from the side of my webcam and took off the faceplate. Next, I pulled apart the housing, which released the mounting point at the bottom. After that, I measured the complex geometry and recreated it in TinkerCAD. Then, I cut the mount point off the dual GoPro adapter and attached it to the new piece. Realizing that the original geometry wouldn't work, I divided it in half and drilled a hole in each section, along with adding a small rectangular attachment to fit into the holes. Once the camera was reassembled with the new component installed, after regluing it of course, I was ready to go.