Logitec C270 Camera Mount for CTC

thingiverse

I printed this out for my CTC printer so I can securely fasten a Logitec Webcam at eye level. It's impressively sturdy and keeps the camera perfectly still, eliminating any bounce that might be expected. The clamp snaps firmly onto all three sides of it, fitting snugly for me. If it doesn't fit tightly enough for you, consider running a screw through it to ensure a secure hold. It sits low enough to avoid obstructing the y carriage but remains high enough to show the build plate, allowing you to record every layer from the first down. I found it easier to snap it onto the screws before sliding it into place where I wanted it. This clamp is 2.5 inches wide, making it simple to mount a raspberry pi to its back without any issues. I didn't get too creative with this design; it's intentionally blocky to simplify printing on my CTC without worrying about cooling.