Lockpick Puzzle 07

myminifactory

Twist and turn the handle on this lock to unlock the secrets hidden inside. My Lockpick puzzles are the culmination of my mission to craft a print-in-place puzzle that emerges from the print bed ready to challenge you! This is puzzle number 7 out of a total of 10. I aimed to make each subsequent puzzle progressively more demanding, yet still within reach for casual solvers. If there's sufficient interest, I can continue and raise the bar even higher :). For optimal results, print at a layer height of 0.15mm. Other layer heights may compromise the ability to snap the handle and lock apart cleanly. A shell count of 2-3 and an infill percentage of 5-10% should yield excellent results. No supports are required; however, you can increase the shell count if you're concerned about the inner rod's integrity. I had no issues during testing. The model shown is printed in MatterHackers White PRO PLA.