Locking part for T-Slot rail

thingiverse

I needed a part to hang severals "guinguette guirlandes" on a brand new pergola. This pergola has a lot of T rails on its design, so I made a part that fit the T-Rail. You could check the actual size of the T rail on picture. Part shall have a locking functionnality without damaging the paint of the pergola (no screw touching the T rail) This item is design in 2 parts. You will need also a CHC M6x25 screw as well a M6 nuts. Fit the nut in the big part, put the screw. The bottom part is a little bit hard to put in position as adjustment is thight : juste enough to move but can not escape. To install the part : put in the rail, turn by 1/4 turn, and then turn the screw to lock the part in position. That it ! Orange prototype on picture is made with PLA. Final devices were made in PETG, for outside usage