Load Cell fixture case (HX711 half bridge) optimized

thingiverse

This is an improved version of [thing:3287167 by tfl4580](https://www.thingiverse.com/thing:3287167). Thanks for your work! * Fixture reduced in height. The original was too thick for our needs and the extra height is not needed for stability. I reduced the inner area to a height of 2mm, which will avoid unwanted infill-layers (depending on your slicer settings) and create a solid base for weighing. * Added feed-through hole for easier cables management. Load cell modules are sometimes slightly bigger than the prepared fixture allows. In case of issues try to increase object size to 102% in x-y dimension. **Long term test:** We have multiple of these setups in use with a permanent load of 30-60kg. One setup is used with a constant weight for reference. Over the course of one year we saw 1) no long-term deviation, and 2) daily and seasonal fluctuations in the lower grams. Summary: Should be suited for all use cases. **Next steps:** This setup was used to build a permanent beehive scale but can be used for any weighing purpose. Check photos for complete setup. We use a Wemos D1 mini and the firmware Tasmota to communicate measurements via MQTT to a home automation software. Nowadays I would recommend ESPHome+HomeAssistant for those playing along at home. There are tons of tutorials online :) Good luck!