Lo-Fi 3.3" / 8cm speaker enclosure

thingiverse

Okay, I'll admit it. This is cuter than it is functional. I'm no sound expert and this design will surely make any audiophile cringe, but --I'll be honest--- they sound better than I expected. I highly suggest to print it with 5 outlines and a wooden filament. The case is for 3.3" speakers. I use [Visaton FRS 8 M](https://www.visaton.de/en/products/drivers/fullrange-systems/frs-8-m-8-ohm) full range speaker, but any similar will do. The body is composed by body + ring + base (held together by 3 pegs). They are divided into 3 pieces just for ease of printing, **just glue them together!**. The speaker is covered by the rim and held by 4 screws that need 3mm threaded inserts. Theoretically there's a reflex duct on the bottom, but I doubt it helps much with the sound quality, just put some kind of sound insulation inside. Have fun! And please do share if you print it.