LJ18A3-8-Z/BX 8mm sensor adaptor for anet e3d adjustable mount

thingiverse

I've obtained the original mount parts from my Anet A8, which were used to remix this design. They function flawlessly. If you haven't printed that part yet, you'll need to obtain the main body of it from there. I attempted printing on borosilicate glass but encountered a problem with the blue cuboid Anet A8 inductive sensor's 4mm sensing distance. It will collide with the glass before detecting the bed. To resolve this issue, I purchased an LJ18A3-8-Z/BX 8mm sensor and remixed this design to allow me to swap out the sensor quickly if needed. However, I didn't want to undertake a large reprint or reflash my firmware to adjust the sensor's x,y location relative to the nozzle. I've printed and tested this remix, and it fits reasonably well, but it requires tightening the two nuts to secure the cylindrical sensor in place. The hole isn't threaded like other designs I've seen. Although I haven't yet attempted printing on glass, I've mounted the sensor successfully. The x location is slightly further out than the original blue sensor due to accommodating the top nut above the hole. The 8mm sensor is significantly larger. My remix was printed in PLA and took approximately 1.5 hours. I hope this helps others upgrade without wasting excessive plastic and time by completely reprinting their mount.