Little Elephant

thingiverse

Little Elephant:\r\n\r\nI designed this model as a basis for a novelty Kossel J6 mount, and I'm rather pleased with how it turned out, so I've posted it on its own.\r\n\r\nLittle_Elephant.123dx / .stl - the primary model\r\nHollow.stl - a hollow version\r\nE_Box_Top.stl\r\nE_Box_Base.stl - to make a little box\r\nWood_E_Box_Top.gcode\r\nWood_E_Box_Base.gcode - My setup to print a "wood-filament" version\r\n\r\nA Little Tip:\r\nI find printing with wood filament is even more of a challenge than ABS. Not so much warping but non-stickage issues.\r\nI've found the best solution for me is to ignore bed temperature advice and crank it up to about 70c, at least initially. Also, I start the print at the upper end of the filament's recommended temperature range and reduce it to the middle after two or three layers.