lithophane night-light base

thingiverse

You can create a one-piece shade for night lights by overlapping a simple lithophane base with your lithophanes in your slicer. This works with cheap Walmart night lights and most others I've seen so far. It's set up for a 100mm wide lithophane with a 30 degree curve, as used in the last picture from 3dprocks. To make both pieces one, manually drag the lithophane base until it overlaps the lithophane, getting it as centered as possible before printing. In Cura, you can set different settings for each piece so you can print the part at .2 and 10% infill, while the lithophane prints at its own layer height and 100% infill. Enjoy this setup!