Lithophane Lamp - Manual Rotation

cults3d

This is My first Lithophane Lamp. I hope you like it. I tried to make this with PLA, but the legs were not strong enough. PLA PRO works much better. I do not sand or finish the parts. Just snap the Bases together and place the magnets into the Lid and top of the Legs. This lamp will hold Up to 9 Photos. I usually configure the with two Tall Prints, four Small Prints and the Square Print for the Lid. The Lithophanes slide into grooves on each side, top and bottom of each opening. There are spacers included to place between two shorter photos. They give it a nice look. Lithophane Sizes: MAXIMUM THICKNESS: 3mm Top; 89mm x 89mm Tall; 87mm x 141.5mm Small; 87mm x 69mm PARTS REQUIRED Magnets: (8) 6mm x 3mm LED Bulb: (1) C37 Candelabra Bulb Socket: (1) DiCUNO E12 Lamp Holder Cord/Switch: (1) Lamp Power Cord Inline Button Switch Wire Nuts: (2) Min. 2x#22 Max. 2x#16 - I trim the ends a little so they fit better. I use Hot Glue to hold the socket in place. You can adjust the center to match any socket you choose to use. IMPORTANT WARNING: USE LED BULBS ONLY! INCANDESCENT BULBS WILL BECOME TOO HOT!