Lipo Battery Holder

thingiverse

This is a clip-on battery holder specifically designed for a 3S 2200mAh Lipo used in Drones. So far, it hasn't been thoroughly tested. Keep reading to find detailed instructions. Update: An initial print attempt failed on certain areas where the walls were somewhat too narrow. I've made these spots slightly thicker and am going to give printing another shot. **Instructions** Still Untested! First, adjust the size of this LiPo holder to fit your actual battery. Print out exactly one copy. Install the 'bezel' and 'end cap' onto your Drone at the correct distance apart. Next, place the 'cap' over the end of the cable on your Lipo. Then, insert the battery through the bezel against the end cap. The clip should securely hold your battery in place.