Linear MINI - precision piezo heated bed mount

thingiverse

<h3>!WARNING!</h3>Parts are Not Meant for Linear Plus Use\r\n\r\n\r\n<h3>---------------------------------------------------</h3>\r\n\r\nThis design is an attempt at creating a heated bed and glass plate mount that also accommodates the "Universal Piezo Z-Probe PCB v2.85," allowing for three piezos to be installed.\r\n\r\n<h3>BOM:</h3> \r\n\r\n<p>6 M4x20 screws are required\r\n<p>6 M4 nuts are needed\r\n<p>6 M4 washers should be used\r\n<p>6 M5x10 screws must be installed\r\n<p>6 M5 20 T-slot nuts are necessary\r\n\r\n<h3>---------------------------------------------------</h3>\r\n\r\n<h3>Installation Instructions</h3>\r\n\r\n<p>Step 1: Insert the M4 nuts into the mounts.\r\n<p>Step 2: Place the mounts on the aluminum profiles without screwing them down.\r\n<p>Step 3: Position the heatbed on top of the mounts and adjust until centered. Ensure the headbed has sufficient room to move up and down within the mounts. Then, screw the mounts to the aluminum profiles. Remove the heated bed afterward.\r\n<p>Step 4: Place piezos in sockets and add spacers on top. \r\n<p>Step 5: Position the heated bed atop the spacers and secure it by clamping the mounts down with screws. \r\n<p> Installation Complete