Linear Bearing 15*8

thingiverse

Hello, This is my design for linear bearings that fit an 8mm shaft. The design was created with the FlyingBear Ghost 4S in mind, but it should work on other printers as well. Use two of these bearings on each shaft. Dimensions: Outer Diameter - 15mm Inner Diameter - 8mm Length of insert part - 30mm (Y) and 25mm (X) Overall Length - 34mm (Y) and 29mm (X) The main files to use are FBG4S_XBearing_25_15_8 and FBG4S_YBearing_30_15_8. I've also included files with inner and outer diameters that vary by up to 0.1mm. You should be able to find a bearing that fits your shaft perfectly, but make sure to polish the inside surface after assembling it and clean out any debris. Scaling from 98 to 102% may be necessary for a snug fit.