Limit Switch Mounting Case Snap Fit

thingiverse

Snap fit for a generic red limit switch that comes bundled with the CNC Uno Shield version 3. No screws are needed, but it's difficult to remove once snapped into place. Print support is required for the two 2.8mm horizontal posts. The funny left ledge is a necessary artifact that will be corrected to a retaining ledge when sliced. The top groove is in a good position for securing with a zip-tie, as was done in my case. The base dimensions come from Costmo's Limit Switch Bracket, which is a suitable choice for securing with screws. I didn't have any screws, so this design was used instead. Customize to fit your specific setup here: https://www.tinkercad.com/things/lKeDmawOSl5. This object was created using Tinkercad.