LightObject Water Pressure Sensor Mount

thingiverse

I purchased a Water Flow / Pressure sensor designed by LightObject for my K40 laser cutter to prevent damage to the laser tube in case of a cooling water flow loss. Upon closer inspection, I noticed that the part depicted on the LightObject website differs from the one I received in terms of hole placement. Nevertheless, I decided to proceed with mounting the sensor under a table connected to the pressure side of the water circuit, but encountered an issue with a shaft protruding below the mounting plate. To resolve this problem, I created a custom mount that elevates the sensor sufficiently for the shaft to clear it. The attachment points on the mount are designed for #6 screws (4 mm in diameter) and the sensor is secured to the mount using #4 screws (2.4 mm in diameter). I have included an .f3d file generated by Fusion 360, allowing you to modify the design as needed if desired.