Lighting Remote Holder

prusaprinters

We have two remote controlled lights in our bed room that we can control with a little remote. Every evening we searched for this remote since our two cats liked to play with it or place it somewhere else than our bedside table. So I made a little holder that keeps it next to the bed. The remote is about 3.5cm wide and 1.6cm deep, it fits in with some air around it. The holder itself is 4cm high. It supports the remote enough to ensure it doesn't tip over but all buttons can be reached easily. Design is made with Autodesk Fusion, Printed with a printrbot simple metal Instructions Just print (standing up of course) and glue it to the wall with a poster strip. I printed it with 100% infill (The walls are quite thin so they can be printed with 3-4 lines of plastic. Category: Organization