LIghter magnetic holder

thingiverse

A hacky mashup of Jewcockie's Cigarette pack + lighter holder design. We use natural gas in our kitchens down here in South America, so I prefer to keep the lighter close by, which is why I used to use electrical tape to attach a magnet to it and place that near the stove. With this mix, you essentially create a sort of wristband for the lighter. To assemble it, just pause the print before the last layer is finished, then stick a magnet between the outer wall and the sleeve. The printer should seal off that gap last, leaving your magnet safely inside the sleeve. This project is a quick and dirty hack. I printed it out in TPU at 240/50 for a functional result.